Cut-Weld-Drive Forums

Cut-Weld-Drive Forums (http://volksrods.com/forum/index.php)
-   Members Intros and Project Updates! (http://volksrods.com/forum/forumdisplay.php?f=9)
-   -   Everette - Intro & V-Rod build (http://volksrods.com/forum/showthread.php?t=38126)

Everette December 8th, 2014 12:56 PM

Everette - Intro & Volksrod build
 
Hi all,
Just recently acquired a '69 beetle project and decided to make it a v-rod before I really knew how large the v-rod community was. The car was basically a pan, body shell, with trans-axle. Other misc. parts were included with the purchase. We were lucky to find this car in such good condition (virtually no body rust). It appears the previous owner kept it covered in its resting place (in the woods). Started this thread in hopes to have a place to ask questions as I go.

Here are some pics of the retrieval:

First thing we did was separate the body from the pan and cleaned out all of the pine needles.

Placed the body on a dolly:

Started patching the floor:

Ordered my 10" extender from Doug and rattle bombed it:

Lowered the rear of the car 2 inner splines. Wheels seem to stand up pretty straight:

I ordered the set screw type beam adjusters to lower the front so that I could pre-load if necessary. Here are some installation pics:

Update 2/11/2015: New brake calipers!

Bolted the motor on to prepare for trimming off the rear apron

Everette July 6th, 2015 05:37 AM

Re: Everette - Intro & V-Rod build
 
Current progress and photos. Body cut and test fit on the pan. Will start building the framehead brace next...

Everette August 20th, 2015 05:29 AM

Re: Everette - Intro & V-Rod build
 
I haven't had a lot of time to work on the build but my father has been able to do some things that needed to be done. Latest progress pictures...
Trimmed hood for steering box clearance.
https://lh3.googleusercontent.com/ZP...w1434-h1075-no
Mock up seat to set steering column height.
https://lh3.googleusercontent.com/lG...w1434-h1075-no
Steering linkage parts!
https://lh3.googleusercontent.com/gp...w1434-h1075-no

Everette October 10th, 2018 12:54 PM

Re: Everette - Intro & V-Rod build
 
It's been quite a long time since any updates were posted to this build. We are beginning to get back on it now. My dad picked up these wheels that were pulled off of a T-bucket. I think they will look quite nice.


All times are GMT -8. The time now is 09:23 AM.

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2020 Three Pugs Design - Cut Weld Drive Forums