Cut-Weld-Drive Forums

Cut-Weld-Drive Forums (http://volksrods.com/forum/index.php)
-   The Cutting Board (http://volksrods.com/forum/forumdisplay.php?f=5)
-   -   copper strip in ignition switch (http://volksrods.com/forum/showthread.php?t=38646)

yimbo April 29th, 2018 01:41 PM

copper strip in ignition switch
 
I was replacing the electrical portion of my 70 vw beetle's ignition switch and in a shallow groove along the inside wall is a copper strip and a piece of cellophane looking stuff that may have covered it laying off to the side. What is it and what do I need to know about the placement of the copper and cellophane strip to make sure everything works as it should. Thanks in advance

yimbo May 3rd, 2018 03:34 PM

Re: copper strip in ignition switch
 
Found out the copper strip is for the key left in the ignition buzzer that goes off when you open the door with the keys in the ignition. So you guys can rest now.

V8Transporter May 3rd, 2018 04:46 PM

Re: copper strip in ignition switch
 
That's good to know. I recently decided to upgrade the '65 Corvair ignition switch in the single cab with a period correct VW switch. :huh: Though, now that I think about it, this likely does not apply to me as the doors don't have any switches for anything.:ohmy:
It's nice to have the info to pass on. :thumbsup:


All times are GMT -8. The time now is 03:47 PM.

Powered by vBulletin
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2013 Three Pugs Design - Cut Weld Drive Forums