View Single Post
Old December 27th, 2008, 03:17 PM   #1
bugdust
Forum Member
 
bugdust's Avatar
 
Join Date: Dec 2002
Location: Middleburg, FL USA
Posts: 8,812
Member Photo Albums
Default Long shifter (pic heavy)
Re:: How-to: Build a bug long shifter: Ver. 1   

I've built a few (6-8) long shifters over the years. I have built most of them one way which I will document and post as soon as I get time and parts to do another shifter. I decided to take a few pics as I built one today a different (easier) way.

I started with a stock 68+ bug shifter. They are cheap and plentiful. I stripped it down to the basic shifter.



The little spring-loaded ball (not really a ball) has to come out so a roll-pin can be inserted to keep the shifter straight. I just clamp the shifter in the vise and grind across the ball. It doesn't take much and then the ball will pop out.




I don't remember the actual size of the roll-pin (I got them a long time ago). I have used JB Weld to hold them in and I have just tapped them in with a hammer. Do whatever you like.



Then I use a cut-off wheel to cut the end of the shifter off with about an inch and the threads. I will use this later. I also cut off the other end leaving about 1-1/2 or 2". Discard the center and keep the two ends.



I clean up the cuts with a grinder, bevel the edges and then use a step-drill to clean up the inside (both pieces)


I bought some 1/2" tube at the local hardware a few years ago. You can buy it in 4' lengths but it's a little pricey that way. You can also get it at Tractor supply and Home Depot, etc. Grind a bevel on one end of your tube as well.


To sleeve each joint I used a 3/8" carriage bolt that I cut the head off of then cut in half. You can use whatever you have. I had to grind the threads a little to get it to drop in the shifter.




Here's the parts so far


I slid one of the bolt halves into the shifter and then the 1/2" tube over that. I clamped it to a flat surface and welded it together





I used the bench grinder to take off most of the weld and then the soft pad to clean it up the rest of the way



More pics in a minute
__________________
my photobucket page

Quote:
No pics, but oh well, if you really, really need to see metal removed, turn off your computer and work on your car... ~ Ray-Dean
bugdust is offline   Reply With Quote