View Single Post
Old March 11th, 2014, 07:57 AM   #26
markh
Forum Member
 
markh's Avatar
 
Join Date: Jan 2008
Location: Vancouver, WA
Posts: 661
Default Re: 1930 Roadster Volkster

Still working on the rear end of the beast. After all the fitment, re-fitment, alignment, adjusting and cutting and welding, the trunk lid was a 1/4" out of square. That quarter inch caused a lot of havoc, but I have it now where the trunk lid opens and closes without interference. Now within approximate tollerance, I was able to get the upper deck panel tacked in place.


Yes, I cut a big 'ol hole in the top for fresh air louvers welded in.

Before I inserted the rear inner panels in the engine compartment, I spent a good deal of time measuring the gap between the rear tires and the inner fenderwells to make sure they were symetrical. To lock them in, I welded tabs to hold them firmly in place.


Eventually I'll move to t he front end of the car and finish off that metal work. Still have the internal panels and vert cross brace to work on next...

Last edited by markh; July 23rd, 2017 at 10:54 AM.
markh is offline   Reply With Quote