Thread: Hood Ornament
View Single Post
Old December 13th, 2011, 07:19 PM   #79
jaransonT3
Type 3 Nut
 
jaransonT3's Avatar
 
Join Date: Jan 2005
Location: Dearborn, MI
Posts: 3,304
Default Re: Hood Ornament

Quote:
Originally Posted by Unkl Ian View Post
Don't forget the draft angle.
Roger that.

Didn't get as far today as I had hoped. I did manage to come up with the cut sheet for the basic elements of the hood ornament. The top, short pattern will be cut from 3/16" material. The bottom, longer pattern will be cut from 1/8" material.



It will all be cut from balsa to start.....on the new laser cutters that I got trained on tonight at the new TechShop here in town!!!

Then I will put it all together, sand and fill it, soak it with SuperGlue to harden it and see where I am at. If all goes well, I can send it to Unkl Ian for a quote on getting it cast.
__________________
Later,
John Jaranson
'66 Square (Sophy)
'69 Square (Panel wanna-be)
'70/'71 Fasty (Jane - the Lead Sled project)

My Home Page
CarArt by John Jaranson
2010 Type 3 Invasion
jaransonT3 is offline   Reply With Quote