View Single Post
Old September 25th, 2009, 01:05 PM   #8
Forum Member
PJLOval's Avatar
Join Date: Aug 2006
Location: Coldspring, Texas
Posts: 1,359
Default Re: Front end alignment basics

What type of adjusters did you weld in? If they are the non-Avis type that require you to cut out a section of the beam then my guess is you cut out too little and that side of the beam is a bit too long. The steering box is always located in a set position for the driver's side so any change in length would show on the passenger side. I'm also assuming you didn't narrow the beam either. It wouldn't take much to be way off at the leading edge of the tire like that. If everything is mounted correctly, just adjust that tie rod and get it back in line.
To quote John Buttera," ...making a car look complicated is easy, making it look simple is hard..." R.I.P.

The sign of a good musician is knowing when NOT to play.
PJLOval is offline   Reply With Quote