View Single Post
Old September 25th, 2009, 01:23 PM   #9
Forum Member
rostigbug's Avatar
Join Date: Nov 2008
Location: tucson AZ
Posts: 2,337
Member Photo Albums
Default Re: Front end alignment basics

Originally Posted by PJLOval View Post
What type of adjusters did you weld in? If they are the non-Avis type that require you to cut out a section of the beam then my guess is you cut out too little and that side of the beam is a bit too long. The steering box is always located in a set position for the driver's side so any change in length would show on the passenger side. I'm also assuming you didn't narrow the beam either. It wouldn't take much to be way off at the leading edge of the tire like that. If everything is mounted correctly, just adjust that tie rod and get it back in line.
All super good points PJLO!!!
Lemme also chime in I suggest that the measurement is inaccurate. Perhaps it is not as far out as we think. Maybe it just needs to be more carefully measured.
heuristic paradigm
rostigbug is offline   Reply With Quote