View Single Post
Old September 11th, 2010, 11:24 AM   #70
Forum Member
FONZY's Avatar
Join Date: Mar 2005
Location: Sanger, TX
Posts: 2,820
Default Re: '37 Volkster Coupe

...and now that i look closer i see yer woah.

the 'hood section you grafted in is too tall... needs to be sectioned down so the line from the trailing edge of the back of the roof section flows downhill to meet that front hood section... make sense? if you take the hood section off, cut out the inner support structure from it, then flatten it ot a bit on the ground, shave it to fit *will be too wide* should getcha goin in the right direction again:)

or .. or maybe just slide the whole thing south about 6-8". the trick is that part of the hood is too flat... most times when guys are building a 'hebmuller' style rear deck they use more of the center or middle section of the front hood... more curves in it ...

Last edited by FONZY; September 11th, 2010 at 11:26 AM.
FONZY is offline   Reply With Quote