View Single Post
Old April 6th, 2011, 04:58 PM   #49
fernon
Forum Member
 
fernon's Avatar
 
Join Date: Jan 2008
Location: Margate, Florida
Posts: 755
Default Re: Fat Chicks n' Mopeds

Donkey Punch

Back to work on the Volksrod, I wanted to do something to the side walls to clean up the inside of the trunk area, so I broke out the cardboard and started to draw out what I wanted to do, then I transferred it to steel and proceeded to cut it out.

After cutting out my pattern it was time to do a test fit and then a bunch of trimming. I am not sure if I want it to come down more but I can't do anything else until I pick up some more steel.

After I make my decision I will begin to put the details into the piece, and to help me do that I went and picked up this neat little toy. It is a Hydraulic Punch Driver Set so that I can make big holes in steel faster than doing it the manual way.

I will try to lay out the inner side piece and punch it out before I Dimple Die it so I can get a feel for what it will look like.
__________________
My Volksrod Build (Fat Chicks n' Mopeds)

Forum Members Comments (Fernon's Chop)


[SIGPIC][/SIGPIC]

Why do you have to "put your two cents in,"
but it's only a "penny for your thoughts"?
Where's that extra penny going to?


Just remember saying I'm sorry and appologizing are the same thing.
Unless you are at a funeral.

Last edited by fernon; August 1st, 2017 at 09:44 AM.
fernon is offline   Reply With Quote