Thread: Bad Kitty
View Single Post
Old December 11th, 2016, 03:04 PM   #2
whozawhat
Forum Member
 
whozawhat's Avatar
 
Join Date: Oct 2008
Location: Xibalba
Posts: 123
Default Re: Bad Kitty

Finished the parts that join the blower to the mount.



A couple of serrated adjustment plates found inside a Harley Davidson primary drive case and normally used to adjust chain tension have been repurposed to use in the mount for adjusting pulley alignment.






A deep sump oil pan was fit.




high rev valve springs installed




and rockers adjusted and checked for coil bind.




Engine case was tapped for full flow and a Berg pressure relief pump cover was fit.




Cooling tins were trimmed to allow the mount supports to fit.




Lower breastplate tin was modified to allow clearance for the extra drive pulley.



The next step will be making a mount for a belt tensioner pulley. Then starting the intake manifold and upper blower brace.

__________________
Quote:
Originally Posted by purplemyth View Post
Want nice? go to Samba or the HAMB.
whozawhat is offline   Reply With Quote