View Single Post
Old April 29th, 2005, 09:59 PM   #4
Forum Member
p-nor's Avatar
Join Date: Feb 2003
Location: paso robles, ca.
Posts: 3,358

what kind of shape is the needle screw in? if either the screw or seating surface are worn, due mostly to over tightening, then it won't work right. throttle shaft? is it nice and tight? if all that was done to the carb was clean and put in a kit, it might need more. those old 28's are over 40 years old and there's lots of worn out ones out there.

this is an electric choke 28? is the choke opening propperly?

i'm just throwing out stuff as i think of it. good luck.

i'm really scared but i'm even more confused, so i end up doing nothing.

-- -- -- -- -- -- -- -- --
p-nor is offline   Reply With Quote