Cut-Weld-Drive Forums

Go Back   Cut-Weld-Drive Forums > The VolksRodders Forum > Members Intros and Project Updates!

Members Intros and Project Updates! New member introductions and project updates...
Your ongoing "journals"...


User Information
Your Avatar

Stuff to check out...

Cool stuff you NEED!

Forum Stats
Members: 17,564
Threads: 32,402
Posts: 547,855
Total Online: 579

Newest Member: Tylerted

Latest Threads
- by marnat3
- by Bugula
- by Ozrod

 
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old April 7th, 2013, 08:31 PM   #1
markh
Forum Member
 
markh's Avatar
 
Join Date: Jan 2008
Location: Vancouver, WA
Posts: 661
Default 1930 Roadster Volkster

Ok, so let's get started on something new. It's been a while since cutting up anything and with this old rendition out there floating around, I thought, why not.

Where to start? How about a complete running '68 Convertible that needed a little a trim?



Ok, so here was the hard part. Locating some decent '29-32 Ford rear quarter panels and trunk lid to start. Got lucky and found '29-30 steel in not too bad of shape. With a couple bolts and a number of vice clamps, threw them on to see what would happen:




Not quite:


After much debate decided the rear wheels need to move back 3" and the body back 5". That left me to cutting the quarter panels and moving it back until it cleared the motor:


With the wheels moving back with the help of an IRS swap and 3x3 trailing arms, the proportions should be close plus a couple inches of junk in the trunk. Still searching for the new arms, trans, axles and pivot points.

Speaking of the trunk, here's a arse end shot:




This past weekend at the PDX swap meet, found just the parts. Here is a lower panel I had to fabricate out of some random panel that had all the right contours top to bottom and side to side:

Quarter panels:

It will need some alignment and a serious amount if internal skeleton work to mount it to the bug body.


You may find photos out of sequence following the re-post of this entire thread.

Last edited by markh; July 23rd, 2017 at 12:13 PM.
markh is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -8. The time now is 04:40 AM.


Powered by vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2020 Three Pugs Design - Cut Weld Drive Forums