Cut-Weld-Drive Forums

Go Back   Cut-Weld-Drive Forums > The VolksRodders Forum > Members Intros and Project Updates!

Members Intros and Project Updates! New member introductions and project updates...
Your ongoing "journals"...

User Information
Your Avatar

Stuff to check out...

Cool stuff you NEED!

Forum Stats
Members: 17,564
Threads: 32,386
Posts: 547,511
Total Online: 363

Newest Member: Tylerted

Latest Threads
- by RichG
- by 1slo3
- by 1slo3

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old April 10th, 2016, 04:51 PM   #34
Forum Member
markh's Avatar
Join Date: Jan 2008
Location: Vancouver, WA
Posts: 661
Default Re: 1930 Roadster Volkster

A week later the top is finally finished.

Took a few hours to button up some engine stuff including a huge exhaust leak, mount the rear tail light pan and mount the turn signals for the last time. Also had to modify the air intake tube yet again as it was still touching the trunk lid.

Still need to install the plexi rear window and new seal but the plexi is cut and ready.

He also did a headliner in an arctic white suede that looks good.

The seat bottom will need to go back for a slight modification. With all the extra padding in the seat and the added headliner, I now sit too high up and within a half inch of the headliner. I already lowered the rear seat mounts about two inches but it's still to high.

Finally got the timing set so it starts and runs but I will need to do something about the carb. It's got a flat spot, stumbles and idles at two different speeds.

Last thing is tighten up the steering linkage, bleed the rear brakes one more time, permanently install the gas tank and take it for a drive. Only been three years in the making.

Last edited by markh; October 29th, 2017 at 11:11 AM.
markh is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -8. The time now is 11:49 AM.

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2020 Three Pugs Design - Cut Weld Drive Forums